Announcement

Collapse

HUG - here for all audio enthusiasts

INTRODUCTION- PLEASE READ FIRST TO UNDERSTAND THIS FORUM!

"This Harbeth User Group (HUG) is the Manufacturer's own managed forum dedicated to natural sound, realisable by controlling the confounding variables between tthe microphone and the listeners' ears.

For example, the design of and interaction between the hifi amplifier and its speaker load can and potentially will alter the sound balance of what you hear. To reproduce the sounds captured by the recording microphones, as Harbeth speakers are designed to do, you would naturally select system components (sources, electronics, cables and so on) that do not color the sound before it reaches the speakers.

Identifying components for their system neutrality should, logically, start with the interpretation and analysis of their technical, objective performance, as any and every deviation from a measurably flat frequency response at any point along the serial chain from microphone to ear is very likely to cause the total system to have an audible sonic personality. That includes the contribution of the listening room itself.

HUG specialises in making complex technical matters simple to understand, aiding the identification of audio components likely to maintain a faithful relationship between the recorded sound and the sound you hear. With our heritage of natural sound, HUG cannot be really be expected to guide in the selection, approval, endorsement or even discussion of equipment that is intend to introduce a significantly personalised sound to the audio signal chain. For that you should do your own research and above all, make the effort to visit an Authorised Dealer and listen to your music at your loudness on your loudspeakers through the various electronics offered there. There is no on-line substitute for that time investment in a dealer's showroom.

If you desire to intentionally tune your system sound to your personal taste, please consider carefully how much you should rely upon the subjective opinions of strangers. Their hearing acuity and taste will be different to yours, as will be their motives and budget, their listening distance, listening loudness and listening room treatment, not necessarily leading to appropriate equipment selection and listening satisfaction for you.

Alternatively, if faithfully reproducing the sound intended by the composer, score, conductor and musicians over your speakers is your audio dream, then understanding something of the issues likely to fulfill that objective is what this forum has been helping with since 2006. Welcome!"


Jan. 2018
See more
See less

SHL5 and what centre channel?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • SHL5 and what centre channel?

    Guys--I'm demoing a pair of SHL5s at home, running off our Mac MA6500 and they are drop-dead stunning. So much so, my wife want to wire them into the TV and go for a separate voice channel. Ugh! I don't think you can do this with an MA6500, which has only two channels.

    Best advice I've gotten so far is to drive the SLH5s with a Rotel surround sound receiver, which would not sound as good as the McIntosh -- which defeats the purpose of the whole set up. Any thoughts on how to set it up so the Mc runs the SHL5s, and something else runs a voice channel and a pair of B+Ws? Am I living in a fool's paradise? Muchas gracias-- Verbs

  • #2
    Wiring for surround sound {beware of out of phase}

    You'll need a surround sound preamp (outlaw, nad makes them). wire the main channel pre out to your mac power amp and harbeth. get another power amp (parasound makes affordable ones) for your other speakers and a mono power amp ( marantz makes affordable little ones) for your centre/ voice.

    {Moderator's comment: you must be sure, especially if you are combining amps from different brands or different models from the same brand, that all amps are in the exact same phase otherwise the centre may be out of phase. You CANNOT assume that all amps are in>out in-phase. Some are in>out reverse phase. The only sure way is test equipment or use a 5.1 dedicated amp.}

    Comment


    • #3
      Phantom centre image beats centr-channel speaker

      Potentially you are leading yourself up a very expensive path with an unknown outcome.

      To do the job properly, you need another SHL5 for the centre channel, otherwise everything that comes from the centre will sound different to the left and right. Just plonking down any old speaker will give some very strange effects and you will need to be able to adjust the levels of LRC.

      Furthermore, using a surround sound processor is very likely to ruin the sounds you are now enjoying.

      If it were my system, I would settle down with a pair of SHL5 and use them to provide a 'phantom' centre channel. Far more satisfactory and free.

      Comment


      • #4
        Our fabulous C7 - for TV listening

        Hi! Does your TV or cable box have an "audio out"?

        I have my TV cable box audio sent to my preamp. To listen to TV we select the "Aux" source and we're listening via our fabulous 7-es2's! Will that work for you?

        David

        Comment


        • #5
          Trading 2 chanel amp for surround amp?

          Thanks guys. The multiple amp/preamp route sounds like a recipe for trouble. Am thinking of trading the MA6500 for an MHT200, which is designed for surround sound. Any thoughts on that route? Looks like it's about a 1:1 trade if I go used.

          Comment


          • #6
            Stay with stereo ....

            Not familiar with that model but if it's a processor it will most likely spoil your 2-channel music, I've not heard one yet that doesn't.

            Then you have the problem of a centre speaker that will sound different to your l & R speakers.

            Personally, I'd stick to stereo.

            Comment

            Working...
            X